Arctic Silver® Silver Thermal Epoxies provide the following characteristics:

 

 Filler    Silver & Boron Nitride
 Components    Two Part (A & B)
 Mix Ratio, Resin (A): Hardener (B)    1:1
 Function    Thermally Conductive
 Dispenser    Luer Slip Syringe
 Cure    25°C or 77°F
 Electrical Conductivity    Negligible (slightly capacitive) *
 Sold In: Sets Per Gram    20g, 50g, and 90g

  SKU & Product Description
Pot Life
Temperature Range
Specific Gravity
SDS
 QCSE - Quick Cure Silver Epoxy
5 Minute
- 40°C to >150°C **
2.28
Data Sheet
 MCSE - Medium Cure Silver Epoxy
15 Minute
- 40°C to >150°C **
2.54
Data Sheet
 SCSE - Slow Cure Silver Epoxy
60 Minute
- 40°C to >200°C **
2.60
Data Sheet
 XSSE - Xtra Slow Silver Epoxy
90 Minute
- 40°C to >200°C **
2.40
Data Sheet

OEM/Commercial products are sold direct from Arctic Silver, Inc. 

They are not available through distribution.

If you need additional information or would like to purchase, please contact us.
  If you need additional information or would like to purchase OEM / Commercial Thermal Epoxies, please contact us at:
  OEM and Commercial Users:    
  Voice: 559-740-0912
* Arctic Silver Thermal Epoxy was formulated to conduct heat, not electricity. Even though Arctic Silver Thermal Epoxy is specifically engineered for high electrical resistance, it should be kept away from electrical traces, pins, and leads. The cured epoxy is slightly capacitive and could potentially cause problems if it bridged two close-proximity electrical paths.

** Bond strength is weakened at temperatures below 0°C due to crystallization.

*** OEM Products are GHS/OSHA REACH / RoHS 3 Compliant


  Arctic Silver® Ceramic Thermal Epoxies provide the following characteristics:
 Filler    Aluminum Oxide & Boron Nitride
 Components    Two Part (A & B)
 Mix Ratio, Resin (A): Hardener (B)    1:1
 Function    Thermally Conductive
 Dispenser    Luer Slip Syringe
 Cure    25°C or 77°F
 Sold In: Sets Per Gram    16g, 32g and 64g

  SKU & Product Description
Pot Life
Temperature Range
Specific Gravity
SDS
 QCCE - Quick Cure Ceramic Epoxy
5 Minute
- 40°C to >150°C **
1.53
Data Sheet
 MCCE - Medium Cure Ceramic Epoxy
15 Minute
- 40°C to >150°C **
1.50
Data Sheet
 SCCE - Slow Cure Ceramic Epoxy
60 Minute
- 40°C to >200°C **
1.65
Data Sheet

  NOTE:  OEM / Commercial products are sold direct from Arctic Silver, Inc.
  If you need additional information or would like to purchase OEM / Commercial Thermal Epoxies, please contact us at:
  OEM and Commercial Users:    
  Voice: 559-740-0912

** Bond strength is weakened at temperatures below 0°C due to crystallization.

*** OEM Products are GHS/OSHA REACH / RoHS 3 Compliant



© 2022 Arctic Silver, Inc. All Rights Reserved. All trademarks used in this site are the property of their owners.  Join us on facebook.